SlimFit › fit in › Ford Bronco

Will the Graco SlimFit fit in a 2021–2024 Ford Bronco?

Yes — the Graco SlimFit fits a 2021–2024 Ford Bronco, with a caveat.
The SlimFit is about 18.5" wide; the Bronco's usable rear bench is about 49". It fits one rear position comfortably. Three across is tight (55.5" needed vs 49"). Note: rear legroom here is limited, so a rear-facing install may crowd the front passenger.

18.5"SlimFit width

49"Bronco rear bench

Tightthree across

★★★★☆NHTSA Ease-of-Use

Check the SlimFit on Amazon → All seats for a Bronco

🔗 Amazon link is an affiliate link. As an Amazon Associate we earn from qualifying purchases — at no extra cost to you.

What fits this Bronco

One seat, rear position: Yes. The SlimFit installs in an outboard rear position of a 2021–2024 Ford Bronco, though you may slide the front seat forward for rear-facing.
Three across: Tight — three need ~55.5" against only ~49". A narrower seat is the better bet.
Modes this seat covers: rear-facing → forward-facing → booster.
LATCH: lower anchors up to 47 lb; the Bronco has 2 lower-anchor positions.

ℹ️ Informational only — built from NHTSA public car-seat ratings and published seat/vehicle dimensions. This is not a safety certification and not a substitute for the seat and vehicle manuals. Always confirm the fit and install yourself before every trip. The SlimFit's width (Graco published spec (rotating cup holders stow to ~18.5 in)) and the Bronco's rear-bench width (Ford dimensions + owner measurements (approx); body-on-frame, upright rear bench) are both approximate — confirm with a test-fit before buying.

Common questions

Will the Graco SlimFit fit in a 2021–2024 Ford Bronco?

Yes — the Graco SlimFit (18.5" wide) fits a single rear seating position in a 2021–2024 Ford Bronco. Because this vehicle has limited rear legroom, a rear-facing install may require sliding the front seat forward. Three across is tight — its rear bench is about 49" and three of these would need 55.5".

Can you fit three SlimFits across a Bronco?

Probably not — three SlimFits need about 55.5" but the Bronco's usable bench is only about 49". Consider a narrower seat — see our narrowest-seats guide.

Sources: seat ratings & modes — NHTSA (pulled 2026-06-18); dimensions — manufacturer specs and owner measurements. Informational only — built from NHTSA public car-seat ratings and published seat/vehicle dimensions. This is not a safety certification and not a substitute for the seat and vehicle manuals. Always confirm the fit and install yourself before every trip.