Revolve360 Slim › fit in › Nissan Frontier Crew Cab

Will the Evenflo Revolve360 Slim fit in a 2022–2024 Nissan Frontier Crew Cab?

Yes — the Evenflo Revolve360 Slim fits a 2022–2024 Nissan Frontier Crew Cab, with a caveat.
The Revolve360 Slim is about 16.9" wide; the Frontier Crew Cab's usable rear bench is about 52". It fits one rear position comfortably. Three even fit across the back (50.7" needed vs 52"). Note: rear legroom here is limited, so a rear-facing install may crowd the front passenger.

16.9"Revolve360 Slim width

52"Frontier Crew Cab rear bench

Yesthree across

—NHTSA Ease-of-Use

Check the Revolve360 Slim on Amazon → All seats for a Frontier Crew Cab

🔗 Amazon link is an affiliate link. As an Amazon Associate we earn from qualifying purchases — at no extra cost to you.

What fits this Frontier Crew Cab

One seat, rear position: Yes. The Revolve360 Slim installs in an outboard rear position of a 2022–2024 Nissan Frontier Crew Cab, though you may slide the front seat forward for rear-facing.
Three across: Yes — three need ~50.7" against a ~52" bench. Test-fit; three-across is decided by half-inches.
Modes this seat covers: rear-facing → forward-facing.
LATCH: the Frontier Crew Cab has 3 lower-anchor positions.

ℹ️ Informational only — built from NHTSA public car-seat ratings and published seat/vehicle dimensions. This is not a safety certification and not a substitute for the seat and vehicle manuals. Always confirm the fit and install yourself before every trip. The Revolve360 Slim's width (Evenflo published spec (16.9 in — the narrow/3-across rotating model; approximate)) and the Frontier Crew Cab's rear-bench width (Typical for pickup — crew cab — approximate, verify install in your vehicle) are both approximate — confirm with a test-fit before buying.

Common questions

Will the Evenflo Revolve360 Slim fit in a 2022–2024 Nissan Frontier Crew Cab?

Yes — the Evenflo Revolve360 Slim (16.9" wide) fits a single rear seating position in a 2022–2024 Nissan Frontier Crew Cab. Because this vehicle has limited rear legroom, a rear-facing install may require sliding the front seat forward. Three of them also fit across its roughly 52" rear bench.

Can you fit three Revolve360 Slims across a Frontier Crew Cab?

Yes — three Revolve360 Slims need about 50.7" and the Frontier Crew Cab's usable bench is about 52". It's close, so test-fit before buying.

Sources: seat ratings & modes — NHTSA (pulled 2026-06-18); dimensions — manufacturer specs and owner measurements. Informational only — built from NHTSA public car-seat ratings and published seat/vehicle dimensions. This is not a safety certification and not a substitute for the seat and vehicle manuals. Always confirm the fit and install yourself before every trip.