Advocate ClickTight › fit in › Ford Bronco

Will the Britax Advocate ClickTight fit in a 2021–2024 Ford Bronco?

Yes — the Britax Advocate ClickTight fits a 2021–2024 Ford Bronco, with a caveat.
The Advocate ClickTight is about 20.5" wide; the Bronco's usable rear bench is about 49". It fits one rear position comfortably. Three across is tight (61.5" needed vs 49"). Note: rear legroom here is limited, so a rear-facing install may crowd the front passenger.

20.5"Advocate ClickTight width

49"Bronco rear bench

Tightthree across

★★★★☆NHTSA Ease-of-Use

Check the Advocate ClickTight on Amazon → All seats for a Bronco

🔗 Amazon link is an affiliate link. As an Amazon Associate we earn from qualifying purchases — at no extra cost to you.

What fits this Bronco

One seat, rear position: Yes. The Advocate ClickTight installs in an outboard rear position of a 2021–2024 Ford Bronco, though you may slide the front seat forward for rear-facing.
Three across: Tight — three need ~61.5" against only ~49". A narrower seat is the better bet.
Modes this seat covers: rear-facing → forward-facing.
LATCH: lower anchors up to 40 lb; the Bronco has 2 lower-anchor positions.

ℹ️ Informational only — built from NHTSA public car-seat ratings and published seat/vehicle dimensions. This is not a safety certification and not a substitute for the seat and vehicle manuals. Always confirm the fit and install yourself before every trip. The Advocate ClickTight's width (Britax published spec (~20.5 in — the widest of the line, extra side bolsters)) and the Bronco's rear-bench width (Ford dimensions + owner measurements (approx); body-on-frame, upright rear bench) are both approximate — confirm with a test-fit before buying.

Common questions

Will the Britax Advocate ClickTight fit in a 2021–2024 Ford Bronco?

Yes — the Britax Advocate ClickTight (20.5" wide) fits a single rear seating position in a 2021–2024 Ford Bronco. Because this vehicle has limited rear legroom, a rear-facing install may require sliding the front seat forward. Three across is tight — its rear bench is about 49" and three of these would need 61.5".

Can you fit three Advocate ClickTights across a Bronco?

Probably not — three Advocate ClickTights need about 61.5" but the Bronco's usable bench is only about 49". Consider a narrower seat — see our narrowest-seats guide.

Sources: seat ratings & modes — NHTSA (pulled 2026-06-18); dimensions — manufacturer specs and owner measurements. Informational only — built from NHTSA public car-seat ratings and published seat/vehicle dimensions. This is not a safety certification and not a substitute for the seat and vehicle manuals. Always confirm the fit and install yourself before every trip.