Advocate ClickTight › fit in › Chevrolet Spark

Will the Britax Advocate ClickTight fit in a 2016–2022 Chevrolet Spark?

Yes — the Britax Advocate ClickTight fits a 2016–2022 Chevrolet Spark, with a caveat.
The Advocate ClickTight is about 20.5" wide; the Spark's usable rear bench is about 44". It fits one rear position comfortably. Three across is tight (61.5" needed vs 44"). Note: rear legroom here is limited, so a rear-facing install may crowd the front passenger.

20.5"Advocate ClickTight width

44"Spark rear bench

Tightthree across

★★★★☆NHTSA Ease-of-Use

Check the Advocate ClickTight on Amazon → All seats for a Spark

🔗 Amazon link is an affiliate link. As an Amazon Associate we earn from qualifying purchases — at no extra cost to you.

What fits this Spark

One seat, rear position: Yes. The Advocate ClickTight installs in an outboard rear position of a 2016–2022 Chevrolet Spark, though you may slide the front seat forward for rear-facing.
Three across: Tight — three need ~61.5" against only ~44". A narrower seat is the better bet.
Modes this seat covers: rear-facing → forward-facing.
LATCH: lower anchors up to 40 lb; the Spark has 2 lower-anchor positions.

ℹ️ Informational only — built from NHTSA public car-seat ratings and published seat/vehicle dimensions. This is not a safety certification and not a substitute for the seat and vehicle manuals. Always confirm the fit and install yourself before every trip. The Advocate ClickTight's width (Britax published spec (~20.5 in — the widest of the line, extra side bolsters)) and the Spark's rear-bench width (Very small car — narrow rear bench (~44"); typical for subcompact, approximate, verify install) are both approximate — confirm with a test-fit before buying.

Common questions

Will the Britax Advocate ClickTight fit in a 2016–2022 Chevrolet Spark?

Yes — the Britax Advocate ClickTight (20.5" wide) fits a single rear seating position in a 2016–2022 Chevrolet Spark. Because this vehicle has limited rear legroom, a rear-facing install may require sliding the front seat forward. Three across is tight — its rear bench is about 44" and three of these would need 61.5".

Can you fit three Advocate ClickTights across a Spark?

Probably not — three Advocate ClickTights need about 61.5" but the Spark's usable bench is only about 44". Consider a narrower seat — see our narrowest-seats guide.

Sources: seat ratings & modes — NHTSA (pulled 2026-06-18); dimensions — manufacturer specs and owner measurements. Informational only — built from NHTSA public car-seat ratings and published seat/vehicle dimensions. This is not a safety certification and not a substitute for the seat and vehicle manuals. Always confirm the fit and install yourself before every trip.